Search:

Type: Posts; User: CJD

Page 1 of 20 1 2 3 4

Search: Search took 0.02 seconds.

  1. Thread: fill bag's faster

    by CJD
    Replies
    17
    Views
    5,203

    Wakemakers has the best selection of pumps,...

    Wakemakers has the best selection of pumps, hoses, valves and bags I have found in one website.
  2. Thread: mike y

    by CJD
    Replies
    7
    Views
    1,116

    Back firing through the exhaust is ignition. ...

    Back firing through the exhaust is ignition. Back firing through the intake is a stuck valve, burned valve, or a lean mixture. First step would be if it is logging a code in the ECU.
  3. Thread: fill bag's faster

    by CJD
    Replies
    17
    Views
    5,203

    I'm telling you...using an aerator pump and any...

    I'm telling you...using an aerator pump and any kind of valving will be slow. Changing the valves can't make more than a few minutes difference. With the positive displacement Talullahs, I hit the...
  4. Well Bummer. At least you found the crack before...

    Well Bummer. At least you found the crack before it broke off.
  5. Yep, brass is infinitely repairable. They should...

    Yep, brass is infinitely repairable. They should check the post carefully for cracks, but other than that it is a straight forward job. Also, if he is backed up for too long, I would not have a...
  6. Replies
    1
    Views
    466

    Check your alternator belt. The tranny is full...

    Check your alternator belt. The tranny is full of fluid, so not likely to squeal, but anything that changes the speed of the motor could cause the belt to slip.
  7. Replies
    9
    Views
    3,449

    Interesting. My Walther doesn't have any of...

    Interesting. My Walther doesn't have any of those fittings...2005 24ssv. It has a simple square head plug at the very bottom. the only hoses are for water to enter and exit at the top. It's...
  8. Replies
    9
    Views
    3,449

    The drain plug on my 2005 V drive is a square...

    The drain plug on my 2005 V drive is a square head, similar to the 2 square head water drain plugs up at the top of the drive.
  9. Thread: fill bag's faster

    by CJD
    Replies
    17
    Views
    5,203

    I just switched to Tallulah High Volume pumps. I...

    I just switched to Tallulah High Volume pumps. I can board 3600lbs of water in 3 minutes.
  10. Thread: Running rich

    by CJD
    Replies
    7
    Views
    1,194

    Is it a Holley? If so the power valve could be...

    Is it a Holley? If so the power valve could be blown.
  11. Replies
    3
    Views
    1,207

    Interesting. I change the impeller annually to...

    Interesting. I change the impeller annually to prevent that, but I did have a small chunk of one impeller flake off a few years ago. Now I know where to look for it!
  12. I was going to say, exhaust backfire is always...

    I was going to say, exhaust backfire is always ignition. So coil, rotor, cap, wires and plugs are the areas to check.
  13. It is normally up under and against the rear...

    It is normally up under and against the rear bulkhead in the center locker.
  14. Replies
    1
    Views
    616

    There is not a direct link between the exhaust...

    There is not a direct link between the exhaust ports and the engine oil...I don't think those are related. Water in the oil would be from a crack in the heads or block, or bad head gasket. If an...
  15. Replies
    7
    Views
    2,112

    Well...even if it is possible to get vapor lock,...

    Well...even if it is possible to get vapor lock, opening the throttle would not make a difference in that case. Starting better with an open throttle is still the biggest indication of flooding, or...
  16. Replies
    4
    Views
    1,159

    If the positive side is good, then it could be a...

    If the positive side is good, then it could be a negative side connection.
  17. Replies
    7
    Views
    2,112

    +1 to flooding. That likely means an injector is...

    +1 to flooding. That likely means an injector is bad, allowing fuel to drip into the manifold while the engine sits with pressure in the line. Vapor locking is not a problem with fuel injection...
  18. Replies
    7
    Views
    2,951

    Same here for platform depth...just never lost a...

    Same here for platform depth...just never lost a stock pin in the water. Lost 2 when my son helped me remove the platform and he never could remember where he put them. We had to use stainless...
  19. Replies
    1
    Views
    583

    Sounds like an O2 sensor is disconnected or bad.

    Sounds like an O2 sensor is disconnected or bad.
  20. Replies
    7
    Views
    2,951

    I replaced my swim platform and no longer use...

    I replaced my swim platform and no longer use those pins...but the only problem I ever had with them for the 16 years I did use them is losing them when someone else misplaced them. We had to remove...
  21. Replies
    7
    Views
    2,951

    Some of us have to remove the platform for...

    Some of us have to remove the platform for storage, so the pins are a necessity. Here is a supplier:
    ...
  22. Thread: VSR Grounding

    by CJD
    Replies
    5
    Views
    1,523

    What's a VSR? What Mike is trying to say is...

    What's a VSR?

    What Mike is trying to say is the correct answer normally is the easiest ground to reach from where the component is located. At the rear, anything on the engine block, left front...
  23. Replies
    6
    Views
    1,694

    If it helps...we've all been there...

    If it helps...we've all been there...
  24. Replies
    16
    Views
    2,654

    Excellent!

    Excellent!
  25. Replies
    16
    Views
    2,654

    There are Holley spread bores. They were...

    There are Holley spread bores. They were replacements for the old Rochesters. But so far he hasn't confirmed we are dealing with a Holley.

    What happens when you connect the choke wire? Here is...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4