Search:

Type: Posts; User: Wylietunes

Page 1 of 16 1 2 3 4

Search: Search took 0.07 seconds.

  1. Upper and Lower 19015

    Upper and Lower

    19015
  2. You can, I have a pair of each in stock, as well...

    You can, I have a pair of each in stock, as well as a pair of lower "blanks" if one was just going with a pair of upper speakers and deleting the factory lower.

    page #2 has the best picks I have...
  3. @Anderson, As noted, you can source the Edge...

    @Anderson,

    As noted, you can source the Edge blank plates through your Surpa dealer. Or, if you refer to this very thread, there are some custom aftermarket options.

    Have you contacted JL to...
  4. @Anderson, You do not need to source...

    @Anderson,

    You do not need to source un-drilled un-tapped blanks from skiers choice. The ones pictured in this thread are drilled and tapped to fit the popular speaker pod options.
  5. @Anderson, I do not know of swivel Edge option...

    @Anderson,

    I do not know of swivel Edge option from JL, so it would be worth a call them just to be sure.

    Have you looked into the Wet Sounds Icon-8? It can be outfitted with a swivel...
  6. Replies
    2
    Views
    204

    They call that the actuator. its likely custom...

    They call that the actuator. its likely custom etched for Supra. Thats the Contura V series, and you can find them with a variety of etched labels. OTRATTW.net can even do some custom etching.
  7. Replies
    4
    Views
    359

    Your experience with distortion can very well go...

    Your experience with distortion can very well go hand in hand with NOT having external amp power. Head units are historically very week in rms wattage and most tend to tun a full-range output. When...
  8. Replies
    4
    Views
    359

    Can you clarify a couple things? You mention...

    Can you clarify a couple things? You mention surfing, are these going to be tower speaker or in-boats? 2nd, so say you dont want to buy and amp. Do mean a new replacement amp or are these going to be...
  9. Replies
    1
    Views
    217

    Ive been using interstate marine for years, with...

    Ive been using interstate marine for years, with good results. If space permits, go with a group-29.
  10. Replies
    3
    Views
    801

    So where are the other 2? Speakers behind you...

    So where are the other 2? Speakers behind you tend to do little for you, while underway. If there are speakers in proximity to the captains chair and they struggle to be heard underway, external...
  11. Replies
    6
    Views
    1,138

    If the alpine is for looks, then mount it, wire...

    If the alpine is for looks, then mount it, wire it to to come on but skit it all together on the audio signal path. Connect the JL BT direct to the amp. Will work fine with a single amp setup.
    ...
  12. Replies
    6
    Views
    1,138

    Running what, a 1980's alpine of the JL blue...

    Running what, a 1980's alpine of the JL blue tooth?

    The JL BT can eliminate the need for a traditional head unit

    If the head unit does not have an AUX-in, I would not expect it to have an AUX...
  13. Replies
    4
    Views
    487

    You can patch the vinyl just like a tube or raft,...

    You can patch the vinyl just like a tube or raft, but im not sure thats really the fix for you. Sounds like a lose plug or dried oring or both. If this is a used port, I dont see you wanting to cover...
  14. Replies
    6
    Views
    1,138

    dont know what this is. Most amps do not have...

    dont know what this is.

    Most amps do not have dual inputs or switchable inputs. You cannot run dual inputs.
  15. Replies
    2
    Views
    327

    You are going to want to confirm the pre-wire...

    You are going to want to confirm the pre-wire gauge and then do some math. I have a gut feeling that the OEM wiring is not large enough for one, moreless two, LL LEDs due to their step-up voltage...
  16. Static or hum, whine? rpm based or just constant...

    Static or hum, whine? rpm based or just constant with engine running? Is it heard from all speakers or just those driven by a particular amp? Certainly could be a ground loop issue, but not isolated...
  17. Replies
    2
    Views
    695

    CMD8. If you have remotes, its worth just double...

    CMD8. If you have remotes, its worth just double checking that your remote cables are the 8-pin version. M606 would be a better choice but im not sure if they share the same power harness. Worst...
  18. Replies
    6
    Views
    1,611

    Those are likely 24V valves, which is why they...

    Those are likely 24V valves, which is why they indicate 18V min. Honestly, I would a bit more research. The best option is to do away with the valves. They are restrictive and problematic. Give each...
  19. Replies
    0
    Views
    509

    Aeware Remotes

    Anyone have a functioning Aeware remote with cable intact that might loan it in the name of science? Dont care about color or cosmetics, just working. Want to test its compatibility with some head...
  20. Replies
    5
    Views
    1,038

    Thats why I framed the question like I did. Had a...

    Thats why I framed the question like I did. Had a feeling your meter ground reference was not the amp terminal. Glad you found it. its amazing how many calls I field this time of year with batteries...
  21. Replies
    8
    Views
    1,475

    Depending on the v-drive ration (not the trans)...

    Depending on the v-drive ration (not the trans) id likely suggest an entirely different prop, not just a reduction in pitch.
  22. Replies
    8
    Views
    1,475

    back in those days, Cutter was a popular...

    back in those days, Cutter was a popular stainless used among many brands. Hard to make any prop changes without knowing the pitch and dia at least.
  23. Replies
    5
    Views
    1,038

    When taking this reading, to where is the volt...

    When taking this reading, to where is the volt meter ground lead connected?
  24. Replies
    13
    Views
    2,171

    For poops and laughs, we will call this a 4 ohm...

    For poops and laughs, we will call this a 4 ohm nominal speaker, which it is, depending on where you looks. So, this means each speaker is going to receive the amp's potential of 100W rms each, 400W...
  25. Replies
    10
    Views
    1,548

    In regards to alternator supply, this...

    In regards to alternator supply, this configuration leaves you open to isolating the house bank from the alternator, when the engine is running. 2-3 hours of this, before or after anchoring, and your...
Results 1 to 25 of 377
Page 1 of 16 1 2 3 4