The crack appears to go almost 50% of the diameter. If that's the case it's time for a new piece, not just weld it up.
It's hard to tell from your pic if it's just dirty or if the crack wraps...
Type: Posts; User: kevkev
The crack appears to go almost 50% of the diameter. If that's the case it's time for a new piece, not just weld it up.
It's hard to tell from your pic if it's just dirty or if the crack wraps...
When i pulled mine, i bought a complete kit from my dealer. It came shrink wrapped to a piece of cardboard, maybe 10 different seals etc...
Wish I could help. I was going to replace mine this past spring, but after looking at it and realizing how much of a pain it would be to squeeze in there and change it I decided to let my dealer do...
Can you post pics?
I said no originally, but now that I think about it I'm not real sure. It was a few years ago
The minimum response to reply is 10 characters.
No. 10 characters
I removed the bell housing
Did you support the rear end of the engine after you removed the mounts? Mine took a little wiggling and negotiating to remove.
Your front shaft seal is leaking
What he said. I had this happen on my 07 the first summer that we had the boat.
First slide the heat shrink onto the bungee rope. Then loop the bungee rope through your tine, and then use the "hog" clip to pierce both ends of the bungee rope. Slide the heat shrink down and apply...
1461914620
I think they look good. Would love to drive one and see how it is in person sometime.
Any bimini tops?
Everything but drivers seat. It was new when I bought the boat in 12.
I think it was around $2500. I would have to dig up the receipt to tell you for sure
Just give your HID# to the dealer and they will get you the same skins as what came on your boat. I do know that SC normally keeps the patterns for roughly 7 years, so you might want to think about...
I have the same year boat. Manual says 30W, and when I change mine every year that's what I use (also in Texas).
I just talked to them & they have it. Call and talk to Jim.
He doesn't work there anymore. I never asked him a $ figure because I already had one. I'm sure if you call and talk to them, they will treat you right.
Rinkers Boat World. They found it while cleaning out a back room new in a box. The parts guy at the time was a buddy of mine and asked if I needed one. I got a brand new factory one when I bought the...
My dealer here in town has a factory cover that will fit your boat. Might sell it for cheap?
$30 for an additional 350#'s if fully filled is not money wasted in my opinion. You can always fill the bag like a 750, but you can't fill a 750 to 1100. If it were say $100 more, I would agree with...
The ibs helped quite a bit with the length, I no longer feel like I'm riding too close to the platform. I'm sure you could achieve the same result with throwing a spare bag on top of the seat. For me...
I plumbed it to the existing fill & drain lines in the boat. I use a tsunami throw over pump to fill the ibs currently, but plan on at some point plumbing it in to my center bag.