Depending on prop and crew/weight, I ski at 32, but not competitively.
Ours will hit 45 max.
Type: Posts; User: jzelt
Depending on prop and crew/weight, I ski at 32, but not competitively.
Ours will hit 45 max.
I have a bag that leaked at the base of the bag and the outside of the fitting which I think is your issue.
I used some sand paper to scuff the bag.
Packed it full of shoo goo (walmart or hardware...
If you don't want to buy a replacement light, pop one out that works and plug it into the one that doesn't. See if that resolves. If so = new light for the other side.
Verify it is in neutral.
I shut the boat off one time with it in idle.
Everything electronic worked and spent 1 hr going thru everything like suggested.
Went back to try again, pulled on the...
Verify the fuse to the valve. (Ours is located under the dash). You can swap one that works with one that doesn't and see if that debugs the issue.
Cave Run Lake, Morehead KY. We have tied to a houseboat at Raystown before for the weekend, but only as visitors.
We stay the full week at Cave Run.
Go down Fri night and stay in hotel Sat and...
I was referring to the part in yellow. Where the black meets the white is a lip, and any further back the curve of the stern starts to come into play. I have to place mine below or slightly in front...
Depending on your last fill up and how much fuel is left, you could get access to the fuel level sending unit and siphon the gas from there.
I have one from Rural King or Harbor freight, Tractor...
About the only spot I found it suction to was around the Wave on the bottom. Closer to stern and there is the lip that keeps it from getting suction.
Fill the surf side, about 70-80% non-surf.
I...
If it is water related, I agree with Seafoam (get it by the gallon cheaper) and possibly a new fuel filter (or 2) depending on how bad it got.
You don't want Heet as that is alcohol based which...
You can see the blue line off the back. (Over the head of the swimmer and black outboard motor). That is tied to the bow eye of the boat.
18129
This setup has actually saved us from some...
So when we houseboat, I tie the boat to the side like above with bow out.
We do cover it at night. You will need to pay attention to how the water runs off the roof to the sides. In a heavy...
I bought one of these and used a grinder to hack off ~1/2 of the handle....
Same boat and have had this happen to me a few times the beginning of the year.
After a while of it happening, I can now hear the click of the solenoid.
I did clean the battery cables as they were...
It is normal for it to be on in idle (I believe under 1200 rpm?).
Same setup as roosm.
http://www.skidim.com/SWITCH-OIL-PRESSURE-DROP/productinfo/WAL49/
The water pulls thru the v-drive from the intake line. Perhaps (hopefully not) there is a crack from not being winterized?
You could swap it out again, or did you drain it from the plug on the...
Don't over tighten the 3 brass screws. I just snug them up.
Needle nose pliers worked for me to pull it out.
Put Dawn Dish soap on new one and it slid right in.
...
If you haven't mounted the transducers yet, I would suggest using silicon or some temporary adhesive in different areas to make sure it reads at all speeds you want (not interfered with by...
The fuel gauge could be the sending unit.
You can check the gauge by grounding it on the back and have someone watch the needle. I needed to replace the sending unit in the...
I agree with the zerk fitting. To try to mimic it, I packed the support tube with marine grease in an attempt to keep moisture out of the rudder side.
When you installed the TPS, you need to rotate it to get it on the end of the rod. (I don't recall the direction). The first one I installed I did just put it on so the screws lined up and tightened...
Ours is a canister in the v-drive on the starboard side with 2 screws holding clamps into the side of the fiberglass.
I have dual battery setup.
But after a 4 wheeler ride where my battery went, buddy had one of these and it got me thru the day.
He told me he has used it to start diesel truck as well.
...
Air lock? Happens when we go to pump out sometimes. Stand on the bag, have someone turn the pump off and on a few times and see if it starts, since you said you hear it run.
Fooled me! For as clean as everything else is and the custom fabs you have done, I thought you switched the helm too, when you "redid" the interior for as clean as it looks.
No pics yet. It was...