I made one. Turned out great. I took 2 pcs of 3/4 sandy ply from Home Depot, glued and screwed them together. Then cut it down to 66" by 32". Used fiberglass resin only no matting and did 1...
Type: Posts; User: steinkda1984
I made one. Turned out great. I took 2 pcs of 3/4 sandy ply from Home Depot, glued and screwed them together. Then cut it down to 66" by 32". Used fiberglass resin only no matting and did 1...
Installed my FAE last week. It about three hours. This is the best bolt on I have done yet. It was easy to install with little frustration and zero regrettable moments. We surfed and wakeboarded...
No I will highjack your thread. I bought the Airguide speedometer for my 2006 24ssv because the paddle wheel was broken. The GPS speedo works great, super easy to install and set up. My perfect...
I have a 2006 24ssv and the same thing happened to me. Went to pull a rider and idle jumped to 1500 and would not throttle up or down. I ran fault codes and it said pedal position sensor which is...
What did you make the L bracket out of icemanfiz? I really like that design over the ramps.
Mydogzeke, some sort of wakeshaper is a must. Weather the suction cup or ramps is better I can't...
It works great and does the job for less the $100. The only negative is it is pretty big once you screw the two together. I have a 24ssv and I run out of storage when all ballasts are full and we...
I took two of the skate board ramps and bolted them together. The ramps have two small holes on the lip of the ramp. Bought two cans of great stuff and sprayed it in to ensure it floats. Also,...