Search:

Didi the seawater pump go with the engine? Looking for a sherwood g21

After much searching i have found out you arr correct mike. The bolt has to be knicked over a bit. I beleive mine has a wax rope in it. It has double nuts on it like the prop shaft. I havent had the...

Trying to see if my rudder has orings or packing. Pulled the cotter pin, and unkooked the cable from the tiller arm. I can not get the arm off. I can not get the rudder to move down at all,...

Ended up being the gauge. Found a NOS on fleabay and popped it in and now have a working gauge.

Gauge falls to zero as soon as I unhook it from the sender. And goes to 80 hooked up, or with a dedicated wire directly from sender to gauge, to take the factory wiring out of the loop.

Purchased boat last year, had a mechanical oil pressure gauge. Found original gauge behind panel, purchased sierra 18-5899 sending unit and the gauge pegs 80psi as soon as the key is turned on,...

Bounce It- Wale
All the Girls Wanna Ride- Jawga Boyz
Thunderstruck- AC/DC

I put in a pretty hefty size amp (5ch) to run 8 speakers and a sub in my 92 conbrio/impulse. Didn't upgrade alternator and have had no problems, but have noticed that my volt gauge sets lower than it...

Yeah its a fuel pressure gauge you see. The coil is bolted down. But I have also noticed there isn't a resister anywhere in the wire going to it. I even removed the cover over the starter relay, and...

If I put it as the tag says it pops and wont run unless I open the throttle up some. The old 302 firing order, she fires right up and idles like a sewing machine, and is very snappy on the throttle...

1-3-7-2-6-5-4-8 is what is on the engine tag, however it will barely run in this configuration. It runs smooth as butter on the old 302 firing order of 1-5-4-2-6-3-7-8. It was wired 1-3-7 as the tag...

Picked up cheap, runs a tad rough.

PCM 351 with 1:23 Ratio Tranny. I am unsure on the rotation. Its in a 1992 boat.

What is the firing order on this thing? Think the plug wires may be on...