Search:

Type: Posts; User: Stringcheese

Search: Search took 0.01 seconds; generated 55 minute(s) ago.

  1. Replies
    10
    Views
    16,346

    Okay, thanks. I'll check it out in a bit. ...

    Okay, thanks. I'll check it out in a bit.

    Sent from my SM-G975U using Tapatalk
  2. Replies
    10
    Views
    16,346

    I'm doing the same. I hear there is no place to...

    I'm doing the same. I hear there is no place to put the O2 sensor needed for tuning. Following...watch my post too.

    Sent from my SM-G975U using Tapatalk
  3. Replies
    9
    Views
    2,109

    Sounds like a base plate leak. Mine did the...

    Sounds like a base plate leak. Mine did the same. While running, spray starting fluid at the throttle linkage hole where the throttle shaft goes into the baseplate. If you get a few extra revs,...
  4. Replies
    1
    Views
    5,566

    1991 Sunsport EFI upgrade PCM 351W???

    Hello,

    We have mostly restored a 1991 Sunsport and happened across a very good deal on a rebuilt 351W. Our plan WAS to replace the carb with a Holley Scorpion EFI.

    The Local Supra shop says...
  5. Replies
    6
    Views
    20,652

    Davis electronic distributor Sent from my...

    Davis electronic distributor

    Sent from my SM-G975U using Tapatalk
  6. Replies
    6
    Views
    20,652

    Bump. Still available Sent from my SM-G975U...

    Bump. Still available

    Sent from my SM-G975U using Tapatalk
  7. Replies
    6
    Views
    20,652

    Because the local dealer recommended it. They...

    Because the local dealer recommended it. They said they are prone to failure and we take long trips on big lakes. They also went on to say the pro-tec efi engines require using a pro-tec ignition. ...
  8. Replies
    6
    Views
    20,652

    Pro-Tec ignition for sale

    Complete Pro-Tec ignition out of my 1991 SunSport PCM 351W

    Distributor, wiring harness, coil pack, and sparkplug wires.

    Boat ran when ignition was removed this summer.
    ...
Results 1 to 8 of 8