Yes I have taken off the side panel. I thought I may have felt it with my hand but was unable to see. I will put a GoPro down there with a flashlight and hope for the best. Good idea thank you.
...
Type: Posts; User: Evan46
Yes I have taken off the side panel. I thought I may have felt it with my hand but was unable to see. I will put a GoPro down there with a flashlight and hope for the best. Good idea thank you.
...
I have an 08 Supra launch ssv that is leaking oil fast even when off. I believe that it may be coming from the oil drain line connected under the engine. I check the oil every time I go out so I know...
I have a complete new mmdc, gauges, and wire harness. I am trying to replace but 4 of the five gauges have the same wire colors and pin set up. How do I find out which cluster goes to which gauge?
...
When I turn the key to the on position I have zero gauges turning on. The boat will start the fuel pump and turn over fine. The boat will also run fine but no gauges. This started happening...
Have you completed your project? What was the outcome?
Sent from my iPhone using Tapatalk
This is great. I have been wanting to make a hatch on my 2008 to be able to take the plug out on the lift.
Sent from my iPhone using Tapatalk
I believe I had to tap out the sheer pin or key way after soaking it in penetrating oil for 2 days. Then used spacers and hit from the rear prop area. It was a bear of a process though. The bolt...
I could be wrong but looks like a drip less shaft so no packing nut. As far as the coupler, you may not want to mess with it. I had broken my coupler and was told by skiers choice that it is heat...
I used to change the shaft packing on my direct drive with ease. I now have an 08 launch SSV and when I attempted, it looks impossible with normal tools. Does anyone know of a video or can give me...
Maybe the secondary float is stuck. I had the same boat and it happened a lot. You did say it was a new carb though. How many RPM can you get just by reving?
Sent from my iPhone using Tapatalk
The ECM was toast... I sent it in to the link below because skiers choice does not make it anymore. This guy is great. Will diagnose and fix for under $200 if possible. In my case he had to replace...
It does not appear that they go to the ECM but are damn near impossible to to follow. Skiers Choice said they are not aloud to give me a wire diagram but a dealer may give it to me. I am waiting on a...
Tested relays and they are good but not getting power.
Sent from my iPhone using Tapatalk
I was unable to get a wiring diagram. Is there a way to test the ECM/ECU my self?
Sent from my iPhone using Tapatalk
I was going to call skiers choice for a diagram tomorrow morning. Hoping it’s not the ECM..
Sent from my iPhone using Tapatalk
No voltage at the pump and just replaced the key module, still same problem.. I have a multimeter tester but wouldn’t know how to test a relay.
Sent from my iPhone using Tapatalk
Fuses are good just to double check I replaced all three. Still no go.
Sent from my iPhone using Tapatalk
https://uploads.tapatalk-cdn.com/20200517/3771b031c30713b68d9879053fa37a97.jpg
https://uploads.tapatalk-cdn.com/20200517/9ad93b188883eac72c7334ab9a0a5c28.jpg
Sent from my iPhone using Tapatalk
Are these what you are referring to?
Sent from my iPhone using Tapatalk
I pulled them out and looked at them.
I have a 2008 Supra launch worlds edition. I had a bad connection to the starter. Like an idiot I did not disconnect the battery when fixing and arked it. Now when I turn the key to on my gauges turn...