Search:

Type: Posts; User: 2001Sunsport

Page 1 of 5 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    3
    Views
    52

    I believe it is gray. It's terminal E on the...

    I believe it is gray. It's terminal E on the connector at the coil packs. I believe terminal A is yellow so you can start from that end of the connector.
  2. Can anyone tell me what the length of the rudder...

    Can anyone tell me what the length of the rudder shaft is? I'm wondering if either the shaft on this one is too long, if the feature for the tiller arm bolt isn't at the correct location, or if the...
  3. Good to know. Got the interior torn apart for...

    Good to know.

    Got the interior torn apart for the heater install and adding these structural pieces. Using Coosa Composite board instead of plywood in hopes of never dealing with this again. Got...
  4. Both are missing. Going to address the issue in...

    Both are missing. Going to address the issue in the next week or two, I will post pictures of what I do. Thinking about using Coosa board to keep it composite.
  5. Replies
    4
    Views
    297

    1994 was originally fuel injection, it was...

    1994 was originally fuel injection, it was probably acting up and a previous owner swapped it out. I think you'll be fine with the Mallory kit, I missed the part where you said you already ordered...
  6. Replies
    4
    Views
    297

    I assume it still has the ProTec ignition? Does...

    I assume it still has the ProTec ignition? Does it still have the TBI setup or was it converted to carb?

    I'd go with a DUI (Davis Unified Ignition) unit to convert to distributor. If it still...
  7. Replies
    5
    Views
    559

    The stripes make it look like it is sitting heavy...

    The stripes make it look like it is sitting heavy (retaining water) but the platform level looks okay. My 1995 Comp sits with the water just below the stripes and the platform is out of the water by...
  8. From my research if it is the input seal that is...

    From my research if it is the input seal that is leaking, the pump is worn and will need replacing. My 1995 Comp had got water in the trans at some point and had a very dirty neutral, to the point...
  9. I have a rudder with a 1" shaft sitting in my...

    I have a rudder with a 1" shaft sitting in my garage. I can get pictures and dimensions this evening.
  10. Replies
    2
    Views
    644

    Have had the Precision Power brand amps on my...

    Have had the Precision Power brand amps on my boat for the last 3 years. Work great, clear, loud if you want, and cheap. I was looking for another today as the only amp that wasn't Precision Power...
  11. Replies
    153
    Views
    28,154

    1991 (10th anniversary) Comp ...

    1991 (10th anniversary) Comp https://losangeles.craigslist.org/sfv/boa/d/supra-ts6m-10th-anniversary/6555471639.html
  12. Or, am I missing a spacer like this?...

    Or, am I missing a spacer like this? https://www.skiboatpartsonline.com/index.php?route=product/product&path=61_68&product_id=491
  13. 1995 Supra Comp rudder issues and no drain plug

    Have a 1995 Comp TS6M with the GT40 351. I am pretty sure that the previous owner hit something with the rudder, and I am also pretty sure that this is the boat I have now: ...
  14. Replies
    153
    Views
    28,154

    17k for a 1991 Comp... yep...

    17k for a 1991 Comp... yep https://detroit.craigslist.org/okl/boa/d/1991-supra-ski-boat/6482425123.html
  15. Not sure how to accomplish this on a carbed boat,...

    Not sure how to accomplish this on a carbed boat, but on my Sunsport that had EFI, I would pull the plug to the fuel pump and crank the boat for 5-10 seconds. This was done in hopes of getting oil...
  16. If you're looking at the VLX, 2001 was the only...

    If you're looking at the VLX, 2001 was the only year that the VLX had a diamond hull. 2002-2004 the Sunscape was essentially the same boat as the VLX and also had the diamond hull.

    The 98 VLX...
  17. Replies
    0
    Views
    187

    Detroit boat show

    Went to check out all the new inboards and spent a decent amount of time wandering around the Skier's Choice display. Mr. Tinker was there and spent a few minutes talking with my wife and I. We...
  18. I've bought four inboards and sold three...

    I've bought four inboards and sold three inboards. All four of my purchases were found on Craigslist. For the boat sales, two of them sold from Craigslist and the third sold via onlyinboards.com ...
  19. Replies
    153
    Views
    28,154

    Two Comps and a Ryder. I know the red Comp was...

    Two Comps and a Ryder. I know the red Comp was on here at one point to be sold or parted out. It was originally in Fenton, MI, so I guess this guy bought it and needs to get rid of it now.
    ...
  20. Replies
    21
    Views
    1,497

    Just curious, it's posted for 23k here but 21k on...

    Just curious, it's posted for 23k here but 21k on the Detroit Craigslist

    https://detroit.craigslist.org/okl/boa/d/2002-supra-launch-ssv/6465209398.html
  21. I'd be interested in the rudder and RWP, possibly...

    I'd be interested in the rudder and RWP, possibly other items.
  22. Replies
    8
    Views
    636

    I've used SkiSafe for all our boats. Never had a...

    I've used SkiSafe for all our boats. Never had a claim, rates seem good. Easy to set everything up and pay online without talking to anyone.
  23. Replies
    153
    Views
    28,154

    Square windshield. Not sure which model it came...

    Square windshield. Not sure which model it came from but pre 1992. https://annarbor.craigslist.org/bpo/d/supra-windshield/6269740226.html
  24. Replies
    11
    Views
    1,308

    Boat is sold!!

    Boat is sold!!
  25. Replies
    153
    Views
    28,154

    Check this thing out. Says it's a Marauder. ...

    Check this thing out. Says it's a Marauder. Looks like an I/O... https://detroit.craigslist.org/wyn/boa/d/supra-marauder-20-speedboat/6263425253.html
Results 1 to 25 of 103
Page 1 of 5 1 2 3 4