1704717047Rough water and not fully loaded....
Type: Posts; User: Down2Race
1704717047Rough water and not fully loaded....
reading is on new pefect pass stargazer
thanks for the advice. I hadnt adjusted the cables correctly. Got it fixed now. Just had to make sure that pressure was toward idle on the cable. All good
I have a 2001 Launch DD. i keep a 350lb sac in the front ski locker, 800lb sack on each side of the motor, stock 400lb tank under the back seat...along with a DIY wakeshaper like the Ronix Eight.3...
Previously tried the Acme 541...Great improvement over the stock OJ 13x13. Didnt pull near as hard as the 543(not as much torque/acceleration), but same top speed at 4700 RPM. Generally, the motor...
I have a trailer for my 2001 Supra Launch DD. Was looking to get an aluminum trailer. might be willing to part with it... Im in Ocean Springs, MS
I have the Indmar 5.7 TBI 350. Re-propped with the Acme 543 and it pulls hard! great out of the hole and top speed still 43-44mph. Im just worried about the WOT RPMs. Specs say 4200-4800 for this...
got the 10si 105 amp from DB. Works perfect. snug, but fits...thanks!
Boat will not return to idle. Idles 200rpm or so high. Is there a way to tighten the return spring on the throttle body? What is the easiest way to fix the problem? I have PP stargazer, wake...
Alternator has given up on me. So there a simple swap from a parts store that will work. Hoping to find a 95amp. It has the 5.7 Indmar (vortec 350) TBI in it. Any help is appreciated.
I know it's kinda beating a dead horse, but I can't decide on a prop. Looking at the Acme 541 and 543. I run about 2400lbs ballast in my 2001 Supra Launch DD. 800 on each side of the motor, 400...
I just used rubberized paint (for undercoating vehicles) initially to see if it would work. Now, it's fiberglassed and painted with marine engine paint. Yes, it floats. The foam dives it buoyancy....
Just a few pics of my 2001 Launch 21 DD...
The dimensions ended up smaller than I initially stated. I only used 4 of the 7 foam pieces and cut them down as well. In addition to the 550 sacs on each side + partial 350 bag, I also had the...
Well...for anyone interested, it turned out pretty good. Tracking a straight line at 11mph. Just need to fill the 350lb sac on the back seat (it's just filled partially in the vid to offset my...
Gonna sand it and waterproof it after gettin it to the right size...might fiberglass it
Decided to tackle a project. Found some old insulation foam boards and thought I'd try to make a surf wake device with it. Does anyone know the dimensions on the Ronix Surf shaper or the wake shaper...
Just got new motor and full upholstery for my 2001 Launch 21DD. For wakeboarding, currently filling the factory hard tank (400lbs?) and a 550lb sac on each side of the motor. I have a 350lb sac that...