Search:

Type: Posts; User: Evwilliams

Search: Search took 0.01 seconds.

  1. Replies
    3
    Views
    2,098

    Thanks. That is what I tried, it helped.. The...

    Thanks. That is what I tried, it helped.. The real issue was that the back of the motor needed to come up a bit because it was slightly out of alignment causing a tight hold on the coupler.
  2. Replies
    3
    Views
    2,098

    Direct Drive prop shaft coupler

    Im in the process of changing out my dripless shaft seal and ive unbolted the coupler from the trans but it will not separate??? I dont see any kind of set screw so Im not sure whats holding it....
  3. WOW that is a huge price difference! Has there...

    WOW that is a huge price difference! Has there been success with these cheaper parts? I see they also has the ignition coil for like $16 vs the $75 one from skidim.
  4. Thank you! The pumps are working and fuel...

    Thank you!
    The pumps are working and fuel pressure is at 35 + a few when throttled.

    I tested plug wires with a multimeter. they are all good as well.

    After searching endlessly online I...
  5. 97 SunSport direct drive PCM 351w (Stumbling)

    My 97 SunSport has been stumbling. It starts about 5-15mins after I put in the water. No backfire. It feels like a sudden bleep loss of power and repeats then it may smooth out for a bit. Also seems...
  6. Well, I have been able to find cables brackets...

    Well, I have been able to find cables brackets but I dont see a spot to bolt it to on the motor. For the time being Ive used aircraft aluminum wire to twist around the notch and through a hole in the...
  7. 19377 1937819379 19380

    19377
    1937819379
    19380
  8. Thanks Micheal, I checked all parts everything...

    Thanks Micheal, I checked all parts everything looks ok and the transmission shifted prefect by hand. The cable length looked good the issue that I found hat is causing the problem is that a previous...
  9. 97 SUNSPORT Linkage or neutral safety issues

    Hi Everyone,
    I've had some issues on startup at times as I have turned the key and nothing happen until i wiggle the throttle in reverse/forward back to neutral position then try the key. I repeat...
Results 1 to 9 of 9