On my 95 Sunsport the access panel in the floor is to hard to slide without loosening the rear seat and engine cover fastners. Mine also has the bilge type panel in the rear locker and I think it was...
Type: Posts; User: ssa
On my 95 Sunsport the access panel in the floor is to hard to slide without loosening the rear seat and engine cover fastners. Mine also has the bilge type panel in the rear locker and I think it was...
There's no comparison between the way the two of them perform. The Freeride is easier to get up on, easier to ride, it doesn't wear you out as much. The Theory though will out perform it all day. I...
I took the port out of my 95 Sunsport the first winter I had it and there was one or two o rings in it that sealed to the rudder shaft. They would have been accessible from the top side with a o ring...
I remember when this boat first was on here and that one your looking at isn't it. The tower was messed up the way it was mounted.
I've never heard anyone refer to timing as degrees of cam or rotor rotation. Its always expressed in degrees of crankshaft/balancer rotation. The cam turns half the rpm of the crank so there's no...
Yeah if you look at your picture in post 50 of this thread you can see that the exhaust valve is whats located at what would be the front of the motor. Look and you'll see that ajoining cylinders...
What Moor said. You have to make sure that the intake valve was what closed before #1 came up on tdc and that it wasnt the exhaust closing coming up on tdc. In both cases both valves are closed and...
3 wire. It has built in float switch I don't think the Rule you have does. Which is probably the difference in wiring.
My 95 Sunsport had a Sahara 500 in it when I bought it. Factory unit or not I don't know but it lasted almost two years for me. I put the same thing back in it since it was only one I found that was...
After I've drained all the water out of the drain plugs and put them back in I pull the thermostat housing and pour the antifreeze directly in the motor till it fills to the top of the thermostat...
Yeah that's it.
Spent Sunday on Dale Hollow riding around for last time out this year. 16686
I've got 2 wake racks I just removed from my 95. Don't know what they're worth or cost to ship but an alternative you may want to look at is Fluidcore. They're from Australia I put 2 wake/knee combo...
If you hire people worthy of their trade quality isn't a problem. Anyone can build a plain box which is what modular homes typically are. I am also a carpenter and typically do interior trim...
It seems too slow to me also. But 1 minute in on this video they're saying wakeboard speeds and then specifically 23mph. I don't know but I guess I'll find out. Got it half off though so didn't...
Thanks for the reply. What speed were you riding it at? It says you can slow down to wakeboard speeds on their video.
I ordered a HO Freeride last week and it came in on saturday. Was wondering if anyone has one or has tried one out and what you think about it. Figured I'd give it a try for when its too rough for my...
My 95 has a ground connected to the filler neck.
Yeah probably right its been a while since I messed with it. I had to use a set of channel locks the first time to break it loose I guess it had been a while since it had been moved.
My 95 Sunsport is the same. I believe the top is the lock nut break it loose then the other runs the threaded portion in and out.
Ive got that same charger Wotan. Its great.
Coast guard regulations require that the pump only run when the engine is running. My carbureted 95 has a pressure switch plumbed into the oil gallery to kill the pump. Doesn't cost much and is...
I believe skidim sells it in 5 foot increments. I replaced mine over the winter and 15 feet did it. I believe I had about 2 feet left.
Mine has a Accel Super Stock coil installed also by a previous owner. It isn't wired according to the above diagram but it works and I figured if its working leave it alone. For whatever reason the...
Just to clarify you have the positive cable from the battery running to a lug on the remote solenoid. Then from that same lug you have a battery cable running to the battery terminal on the starter....