Scary moment no doubt! I had the same thing haapen whern i was taking a friend and their kids out for the first time. Was a real short trip. Make sure you pulll off all downstream fittings to look...
Type: Posts; User: Sunsport87
Scary moment no doubt! I had the same thing haapen whern i was taking a friend and their kids out for the first time. Was a real short trip. Make sure you pulll off all downstream fittings to look...
Fuel drips in the front bores. I can't really get the motor to keep running at idle. With the trans engage knob pulled out i have to keep the throttle almost full forward just to keep it running. So...
after rebuild I set the mixture screws to 1.5 turns out and floats parallel to top of bowl when inverted. On the water I adjusted both floats down in order to get the valves to close sooner but none...
I am having the same problem and I even rebuilt my carb. My issue is i can see fuel droplets coming down from the bar above the secondaries. I called holley tech. (270-782-2900) and the first thing...
I agree with Doc. Once you shut down on the water the heat has no where to go. This is normal. As long as the temp drops when you start up your fine.
The codes are listed on the home page but each one is only good for 1 year. So if you use one the same code won't be eligible for 12 months. So use the wisely Kimo sa be.
The scenario: 4160 on an 87 sunsport. Started having poor idle condition. Ran great when into the trottle. Noticed gas droplets fgrom the top bar above the secondaries. Got a rebiud kit. Did...
Pull it out and make sure it's clean of debris and the impeller spins by hand with no binding or excessive play. Then keep it out and hook up power and see what it does. As soon as pwer hits it you...
Good advice. I love this boat and I think the investment is woth it. I have called around to some local dealers and can't find anyone who has experience doing a deck repl. On a Supra. I live near...
87 sunsport. 2 small soft spots on deck. This past season I noticed 2 soft spots in the deck. Each about 8 to 10 inched in area. After reading the post on the wood rot I'm certain this is the...
have an 87 sunsport with pleasurecraft 351 V8. Can't run at idle without engine dieing. Runs good once I'm in the throttle and rpm's are up. Pretty sure float is the issue. How do i find out the...