interested in buying the boat with a bad engine
Type: Posts; User: angus2112
interested in buying the boat with a bad engine
where are you at and how much do you want for it shoot me a pm
have interior out of a 87 salt pretty sure some will fit also in north west Ohio south east Michigan nearest town is Metamora Ohio pm me if interested not sure what i have will have to look
yes the cap was off new stringer were all glassed in
please don't lift it like i did that was a roll over for paint after a stringer job
I did pretty sure that's how they did it at the factory 19534
did you get rid of the ballast resistor and run 12 volts direct to the coil not knowing what ohm coil you are running if you have 12v going to it all the time you can burn it up get the right flame...
try ski dim
i have a intake you can have just pay shipping as far as the exhaust drill the end of the cracks v the cracks and use jb weld did it pop any soft plugs
Weak spot on a sbf right side front lower...
i might have 1 when i rebuilt mine i made doubles of most of the wood for patterns modeled my salt seat after it 19267
the super traps are the only thing that holds the ex pipe in it is a wedge fit if you remove them there is nothing to keep the pipe tight ie water leak
if you want it louder put stainless washers...
run a r45ts ac delco or if you want to spend more money mr45ts
are you running points any coil up grade ?
buy the looks getting the right plugs will clear up your carbon issue
I use 1/2 marine on the outside stringer rip it 8 ft long glue together stagier the seams every 4 ft
inside stringer i 1 peace it using lvl or lam beams full 2 inch
there is no gasket between the trans and the engine most likely the front pump seal
do you want all the glass pm me
I have a complete set of glass for a salt no frame
They are taylor made you can still get parts mostly seals. I have a complete set of glass for a salt if anyone needs them. Chopped 6 in out of mine19099
2 school's out there. To foam or not to foam be it nobler to obey all the coast guard laws or save the labor of not doing stringers again ( enough shakespeare ) i dont foam. at the end of the day it...
19037 fill it with foam shape it off put 2-3 layers of 1708 over it to seal the foam
Do it i put a solid mahogany floor in my salt changing all the teak and adding more mahogany 18655
you should be able to get them from skiers choice there was something a few years back where they sent new ones out ( i think i still have them ) for some kind of up grade i will look in my book when...
i will pull it out tonight take some pic and get the part number off it
I have a orignal off a pcm that could be yours
www.integritymarinecorp.com good people to work with just bought some for my salt i think it was $300.00 for everything
.
use 1708 glass round the top of the stringers and make a nice round transition (fillet) where the the stringer meets the hull i use liquid nails it takes some time to dry but does not shrink like pl...