Search:

Im in uniontown, just south of akron

Looking to get a newer supra. 98-02 are the years I'm looking at. My question is are there any issues I need to keep an eye out for when looking? like problems with certain models or what not. Do...

I have a PCM 454 out of an 86 supra complete with tranny ready to bolt up. Motor has maybe 600 hrs on it. Motor runs great and trans works fine. It is a direct drive motor. make me an offer. I live...

Neilmcg,
I am dug into my boat now. I have ripped the floors up and cut all the tops of stringers off including motor mount area. The motor mounts are basically a bunch of plywood pieces put...

+1 ^^ I am in the process of doing the same thing. Im lucky they wernt to bad

dont think you would have to glass it. I like the idea of not having wood. I was fortunate that all my stringers were'nt shot. I am replacing the motor mount with seacast and amd treating the rest...

looking to use the 4 x 8 sheets of pvc board for my floor. Does anyone know if they will be strong enough? they are expensive but after you buy treated ply and glass it, there is not a hole lot of...

I have the same prob on my 86 marauder. curious to know as well.

sick boat. I plan on upgrading in a few years. I love my marauder but I want an open bow.

now thats a great idea. i dont know why I didnt think of that. thanks

cool. thanks for the tips guys. Hopefully taking the boat to my buddys shop to get the motor pulled tonight or tomorrow. I wish my cherry picker would go higher.

I am talking about the round brass coupling that has 4 bolts in it. the shaft runs into it. Does that seperate from the other side?

Im pulling the motor on my 86 supra marauder to begin my quest on the stringers. I have about everything unhooked. How do you seperate the tranny from the shaft? I removed the bolts around it, when I...

its way different from last year. I just pulled the trigger and am tearing her apart and doing the stringers. I just pulled the interior and started poking around. motor mount are shot. So looks...

are the strut bearings in the tranny? The sound is coming from the back of the tranny

it is on land with a flush. Ive never heard this before. the boat vibrates more than it ever has at idle. I can try to pop it in the water this week end and see if I hear it.

thank you. i will call him today

ok so just recheck prop shaft alignment and the shaft sits all the way to the left when going thru the hull. I would assume that it should be centered. So if the prop shaft is now off then my motor...

makes the same noise forward and reverse, but it is worse in revers. shaft alignment looks to be on and spinning same.

chataquasun,
Do you happen to have the contact info for the guy doing your stringer job? if so could you email it to me at [email protected]. I think I am staring a stringer job in the face...

another pic

So finally got the boat started after the tune up. Looked to be in good shape until I hear an awful sound from the tranny. When I put it in gear and ingage it it sounds like something is grinding...

thanks guys. got the boat started today. I pulled it out to put a new coil with internal resistor but the thing just started right up. I thing it may have just need more time to get fuel but my...

Thanks for the info. I am getting the new one today and with my fingers crossed this does the trick and Im back in the water.

So just checked with test light. Pos side of coil weak light. Neg side while crank light barley comes on. Checked power in to white ceramic balast strong light on power in and weak light one power...