Looking to replace my 91 Marauder. Any issues to look for on a 05 Launch? I know there were some recalls. How does the wake compare from my 91 to the 05 at ski speeds? What would be the $range on...
Type: Posts; User: zsuprausa
Looking to replace my 91 Marauder. Any issues to look for on a 05 Launch? I know there were some recalls. How does the wake compare from my 91 to the 05 at ski speeds? What would be the $range on...
I sent you a private message. Give me a call.
Steve
I have been chasing down a leak at my transom and have located it. I noticed when the boat is coming off my lift (a front hinged Float Air) or off the trailer that I have some water cascading down...
Thanks for the info. Going to put it on the trailer and try to fix it next week. A couple of other questions if you happen to know the answer:
- Is the pipe coming out the transom one piece all the...
Are the flange screws just lagged in? No nuts on the back. Any sealant recommended over others? I am also assuming that the exhaust pipe is one piece back to the rubber hose off the manifolds. ...
I have attached a few pics. Sorry for the quality. I was hanging upside down from the swim platform for the internal shot since my boat is sitting on my lift. I am the second owner and this is the...
Can anyone give some insight on resealing the exhaust exits. My 91 Marauder is taking on a little more water than normal and I am guessing it is through the exhaust. When the bilge pumps the water...
I have a 91 Marauder with PCM 454. I ran it in the driveway this spring after dewinterizing it and rebuilding the carb. Ran fine. Put it in the water and the water pump broke after about 3...
Discount Inboard Marine has them. $9 a piece. If you do a complete rebuild the kit comes with a plastic "choke rod" seal. In order to get it out you have to slide out the choke shaft. The only...
I talked with tech support at SKIDIM. They said these can be challenging to get out. They suggested working a chisel with light taps under the small lip on the vent tube. That worked. The first...
Actually if you are going to soak the carburetor to clean it you need to remove the choke rod seal since it is plastic and would deteriorate in solvent. In order to get the seal out you have to...
I am rebuilding my 4160 Holley. In order to get the butterfly valve out you have to remove the J shaped vent tube at the top of the barrel. When I tried to remove the vent tube it just snapped off...
I was talking to a friend of mine who drag races and we got off on a tangent about oil. He highly recommended that I should use Rotella 15W-40 in my 91 Supra Marauder with the PCM454 or go get a...
140 to 160 for me. 91 Marauder w/454PCM
Discount Inboard Marine is always a good place if you can not get it at the local auto store. For the most part their prices have been in line or slightly less then NAPA and Advanced for the same...
Next time I take the boat out I will take a picture. I am leaning towards it came that way from the factory. If someone had tried to reinforce the stringer after the fact their would be 2 empty...
You may want to check the viscosity of the oil you are running. I have a PCM 454 in my boat. In the spring the oil buzzer goes off routinely at idle in the early spring. Once summer hits I never...
I have been looking at all the stringer posts and started looking more closely at my boat (91 Marauder). I am the second owner and the original owner said the boat was all original. I was checking...
We have been looking to move to Hartwell. We started looking at homes 2 years ago. Unfortunately we have been unable to sell our home in Tampa. Considering renting a house for a week this summer...
Some interior pics
Here are the pic's of the repair. The nail polish I found was close but not perfect but a lot easier than making a big patch and sanding. I have ran the boat for about 6 hours since the repair and...
I went with the Aquamend since the hole was so small. I then took some of the wife's nail polish that was close to the gel coat color and dabbed it on the white spot. You can't see a thing until...
I have a 91 Supra Marauder. I found a BB sized hole in the gel coat about 18" above where the water line would be about 3 ft back from the bow. My guess is a stone or small rock kicked up when I...