I have a 1988 Comp and just put an OJ 13x11.5 on it last week. Runs great-42mph on the top end. I have always had Mastercraft's in the past, I have noticed with this boat it does seem a little sluggish.
I have a 1988 Comp and just put an OJ 13x11.5 on it last week. Runs great-42mph on the top end. I have always had Mastercraft's in the past, I have noticed with this boat it does seem a little sluggish.
Well, you can put this thread to rest. The issue of my lack of power and bogging has been found and not resolved....
I need a new motor/rebuild. Compression on the motor was way low. #8 was at 105 psi and everything else ranged from 110-118 psi and according to the specs a strong healthy motor should be at 150 psi and not ranging more than 5% per cylinder.
SOB!
Are there any good engine builders in the Southern Ontario region? (Canada).
1985 Supra Comp TS6M
351 Windsor - 240 HP
Velvet Drive - 1:1
Fully Rebuilt
Looking for users manual and / or wiring diagram for 1985 comp ts6m comp. Any help would be much appreciated.
Sent from my iPhone using Tapatalk
Im pretty sure 105 in one cylinder and 110-118 in the rest is not an insane difference. That wouldn't be causing it to bog down and stop surely? It is low but are u sure that's what the problem is? If it runs ok for a bit then dies doesn't that suggests something else.
Compression is not your issue. Keep searching my friend.
Last edited by MarbleFalls; 07-02-2016 at 03:45 PM.
'85 Supra Comp TS6M
If the wiring diagram is the same as an '85 Supra Comp I sure could use one as well. [email protected] Thanks!!
'85 Supra Comp TS6M