trim tab - wake plate

[Jdm89supra]

I guess it is really a wake plate. looking to see where I can buy parts for it my mounts on my plate not to the hull. the plate have worked themselves look and have gotten to the point of not being able to tighten them down. I just really need to replace them but don't know wher to get parts. can someone point in the direction to go. overtons dosnt have it by the way. and yest they are ariginal hand tighten stile. also could I or is it possible to change it to hydrolic with factory plate

[99bison]

I am sure you can swap it, look at Bennett hydraulic or lenco electric plates. I am putting on an x-22 from bennet right now, just because that was the factory setup in year of my boat.

[SquamInboards]

Can you post a picture of what you're talking about? I have two of the adjusters from an '85 comp, but I don't know if that's what you're looking for.

[Jdm89supra]

thanks for the replies. after a few hours on the cnc I just maid the mount brackets that the adusting rods mount to on the wake plate