Need new ring gear flywheel!

[awesomesteven]

Finally! Here is the end result.uploadfromtaptalk1369007543236.jpg

Hope it helps if someone has the same issue I had with the transmission stuck or having difficulty removing it.

[td in nc]

This post was very helpful for me. My only suggestion instead of the nut on all thread method, is to drill a hole in the bell housing and take off the bolts which connect the damper plate to the flywheel. Once I did this the tranny slid right off. I had to drill two 1" diameter holes into the bell housing and was able to back off the nuts pretty easily.

tranny 3.jpg

[lively]

Well atleast the flywheel and damper plate can breathe better now ! Looks like a tough one to get off ! I always use heat when metal is stubborn . And a mini 10lb sledge lol


Sent from my iPhone using Tapatalk

[premierproperties]

I just did this job and pulled the motor, was way easier to see everything out in the open. Took about 2 1/2 hrs to pull, a little quicker to put back in. It's a full day job

[Blakelpd5]

Is your motor the 351 Steven?


If so, do you happen to have the part number, or what info you used to describe this to napa? I need the same part....

[lively]

yes just tell them you need one for a windsor 351 , 1986 year , Left hand rotation , or go on ebay and order one

[Blakelpd5]

Lively.

Thank you, thank you!!