Results 1 to 3 of 3
  1. 07-23-2013, 08:24 AM #1
    FULL-THROTTLE
    FULL-THROTTLE is offline Senior Member
    Join Date
    Aug 2010
    Location
    Feeding Hills, Massachusetts
    Posts
    113

    Default Drive Shaft Seal

    I have a 95 hydrodyne, I know its not a Supra but still a great boat, anyways the driveshaft seal is dripping approx 1 drip per second, it is a white plastic nut and housing, it has a long cotter pin through both of them? I believe I just need to remove the nut and tighten it a little. Has anyone seen one like this?.

    Thanks,

    Fran
    Reply With Quote Reply With Quote
  2. 07-23-2013, 12:27 PM #2
    comp92's Avatar
    comp92
    comp92 is offline Member
    Join Date
    Jun 2012
    Location
    Central Wisconsin
    Posts
    47

    Default

    i know there are 2 different types of seals. this sounds right; all you should have to do is slightly tighten the nut. do you have any pics?
    -Mike
    92 Supra Comp
    351 PCM
    Reply With Quote Reply With Quote
  3. 07-23-2013, 04:24 PM #3
    FULL-THROTTLE
    FULL-THROTTLE is offline Senior Member
    Join Date
    Aug 2010
    Location
    Feeding Hills, Massachusetts
    Posts
    113

    Default

    Correction, I meant to say remove the cotterpin and tighten the nut.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules