2. When I put the motor back in the boat how can I tell how far back to put it? I assume just matching it where the exhaust hoses from the engine that meet the stainless exhaust tubes will work?
- The motor location is determined by the prop shaft location. I put the prop shaft back in the boat and then temporarily put the prop back on. Make sure you have about 1/2" between the prop and the prop strut. That will tell you where the trans and engine will need to be

3. I need to replace the transmission cooler, where can I find this part?
- any 5" - 6" oil cooler will work

4. I need to replace the external fuel filter/housing, where can I find the parts?
- Not sure you can find the parts anymore. I replaced mine with a newer Sierra Marine water separator/filter

5. When I attach the throttle cable what position should the transmission shaft be in when the shifter in the straight up neutral position?
- The trans should be in neutral. If there is no indication on the trans, then it will be in the middle of the throw of the shift lever. You normally can feel a click into neutral as the neutral safety switch disengages.

6. Is anyone aware of a how-to video in regards to the steering cable connecting to the steering wheel for this or similar models?
- If you have a rotary which you most likely have, you will just put the end in bottom hole and then turn the wheel until it pulls the cable to the helm. The bottom hole is for when the rudder tiller arm goes out to the port side and the top hole is for when the rudder tiller arm goes to starboard.