Originally Posted by
awesomesteven
Two quick questions before i start tearing apart the floor and the stringers.
1. What's the easiest way to take the floor off? I was thinking about using a skill saw at about 1/2 inch to cut as much as I can and then prying up the rest around the hull. Is that a good plan? How did you guys go about "detaching" the floor where it connects to the hull?
2. What's the best way to make sure the new stringers I put in are the same as the current one's? Has anyone had any success taking old stringers out in one piece? I'm not sure how well this will go since mine might be pretty rotted out.