I have spent quite a bit of time looking for the proper way to wire a newer pmgr starter that I bought at db electrical and cannot for then life of me figure out why I can't get it to work properly.pictures below are what I have come to understand how they are typically wired but I received no instructions when I purchased the starter however there are plenty of diagrams online in ford forums. What happens is that I get a solitary click when I try to start the engine. It will turn over when I wire it incorrectly and basically just use the 12v jumper (I used yellow because it was handy) in the old single wire configuration but I ready that is a sure fire way to burn out your starter. If anyone can help me understand what I am missing I would appreciate it.
Josh