Ordered some new Roswell board rack straps. How do I install them?

[gogger]

I ordered bungee cord straps to hold the boards in the Roswell racks on my 2006 24ssv. They came with two little clips and some shrink wrap. Has anyone installed them before? Not quite sure what to do. I can take some pics tomorrow. Shouldn't be to tough. Just not sure about the clips and shrink wrap.

[gogger]

It came with nothing on them. I have been using bungee cords.

[garyholl]

I'd like to see the pics. I need to do the same thing.

[gogger]

20140714_103235.jpg

20140714_103240.jpg

20140714_103257.jpg

[kevkev]

First slide the heat shrink onto the bungee rope. Then loop the bungee rope through your tine, and then use the "hog" clip to pierce both ends of the bungee rope. Slide the heat shrink down and apply heat to cover the clip.

[garyholl]

Thanks kev

[garyholl]

Gogger, where did you order them? How much?

[gogger]

Found them at www.wakeboards.com

http://www.wakeboards.com/Roswell-s/281.htm

$39.99 each

[HIFLYR]

you can order 1/4 bungee cord on the web and restring it thru the webbing for far less than buying new ones from roswell.

[gogger]

I didn't have any webbing. Mine were completely gone when I picked up the boat.