-
Wake plate gauge says it's not moving full range?
07 21v launch. While using perfect pass and also while not, both the needle gauge and the digital readout (if perfect pass is on and therefore dash screen shows 0 to 100 percent) only show the plate reading about 10 percent when I try to max it out full down and about 86 percent when I try to bring it full up. Is it actually moving full range and gauge is off or vice versa? Any way to reset it? Or anyone have a measurement I could stick a tape measure on it when on the trailer and check full up and down?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules