1987 pcm 454

[leetudor]

Still no spark, could someone send me a picture of there coil and distributor wiring to see if i have mine correct?

[skiman_61]

Still no spark, could someone send me a picture of there coil and distributor wiring to see if i have mine correct?

I will be on the boat tomorrow, God willing and the Creek don't rise. I'll try to remember to get a pic or three for you. Send me your email an I can do it on the spot.
Mine is: [email protected] I have an '87 Salt.

[leetudor]

I will be on the boat tomorrow, God willing and the Creek don't rise. I'll try to remember to get a pic or three for you. Send me your email an I can do it on the spot.
Mine is: [email protected] I have an '87 Salt.

I sent you an email. Thanks

[leetudor]

I got it running today! Timing was 180* off, check valve at fuel was clogged and had to replace the points with a Pertronix kit to get some spark.

https://goo.gl/photos/MESFG3XPJZQRFKpv5

[TitanTn]

I got it running today! Timing was 180* off, check valve at fuel was clogged and had to replace the points with a Pertronix kit to get some spark.

https://goo.gl/photos/MESFG3XPJZQRFKpv5

Congrats! Sounds smooth.

[leetudor]

You guys with an 454, what RPM's are you turning?

[TitanTn]

You guys with an 454, what RPM's are you turning?

Are you talking about WOT? Should be between 4400 - 4600.

[leetudor]

OOPPPSS, Yes WOT. I was out Tuesday and only went to 4200 RPMs. Might go further today.

[wotan2525]

I can run up to ~5200 rpms but it doesn't seem to make much more power after 4700.

[leetudor]

Water traffic and families plan did not allow me to try this weekend.