Page 2 of 2 FirstFirst 12
Results 11 to 16 of 16
  1. #11
    Join Date
    Dec 2012
    Location
    Clark, CO.
    Posts
    587

    Default

    Function before fashion!

  2. #12
    Join Date
    May 2009
    Location
    Peachtree City, GA
    Posts
    31

    Default

    How can I print this to take out with me? I have already replaced the MDC, not doing that again. The temp gauge pegs hot, the oil pressure jumps all over. I worry and the engine runs fine...

    David

  3. #13
    Join Date
    Dec 2012
    Location
    Clark, CO.
    Posts
    587

    Default

    left click a section then right click and select print
    Function before fashion!

  4. #14
    Join Date
    May 2009
    Location
    Peachtree City, GA
    Posts
    31

    Default

    Done. Thanks for your help in all of this.

    David
    99 Santera

  5. #15

    Default

    I’m about to ball up and do this but just have a couple questions.

    Where does the purple wire come from? I don’t see it in the Harness’ picture?

    No issues with your fuel sender? I heard that getting to the tank is nearly impossible on these Santera models due to the tank location. If anyone on here know how to access it please chime in!

    I will be making a video on this so hopefully I can help at least one person.

    Just waiting on the Feria guages.
    1999 SUPRA SANTERA
    LT-1
    HELP...!

  6. #16
    Join Date
    Mar 2020
    Posts
    1

    Default MDC Delete

    Quote Originally Posted by PincheWey View Post
    I’m about to ball up and do this but just have a couple questions.

    Where does the purple wire come from? I don’t see it in the Harness’ picture?

    No issues with your fuel sender? I heard that getting to the tank is nearly impossible on these Santera models due to the tank location. If anyone on here know how to access it please chime in!

    I will be making a video on this so hopefully I can help at least one person.

    Just waiting on the Feria guages.

    The Purple wire is the switched 12 volts. (I assume you mean the one on the Circuit Board and/or the one that goes to the Medallion 1600 controller.

    I found this on the MasterCraft Forum:

    18 Pin Connector (Mostly unused BTW):
    Red (1A)- Constant +12 volts
    Purple (1B)- Ignition Switched +12 volts
    Tan (1C)- Temp
    Blue (1D)- Oil Pressure
    Pink (1E)- Fuel Level
    Black (2C)- Ground
    Gray (2D)- I think this is tach signal (This is the tach.)

    Also found this on the MC Forum: (It does not apply to exactly like the Moomba/United Marine, but was helpful.)

    https://teamtalk.mastercraft.com/sho...ghlight=gauges

    I have a 99 Moomba Outback in which I am currently replacing the gauges to Faria.

    Faria has a troubleshooting document and has a lot of information. On your fuel sensor, you can measure the resistance off the cables.

    FYI, Faria gauges may need an updated sensor (Fuel Tank, Oil pressure, Water Temp.)

    Let Me know if you need any more info or help!

    PS: My Cuz in Columbus IN has a boat like yours and I love that boat!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •