Water Pump Impeller Specs - 1991 Conbrio

[Hercules_ZA]

Hi All

I wonder if anyone can help with specs on an Impeller for the Raw Water Pump on my '91 Conbrio
No of vanes, ID, OD, width, keyway etc.

Any help would be appreciated, no PCM Agents in South Africa

Thanks in advance

Cheers

D


Sent from my iPhone using Tapatalk

[crystal waters]

[QUOTE=Hercules_ZA;122089]Hi All

I wonder if anyone can help with specs on an Impeller for the Raw Water Pump on my '91 Conbrio
No of vanes, ID, OD, width, keyway etc.

Any help would be appreciated, no PCM Agents in South Africa

Thanks in advance

Cheers

D

What engine are you running in your Conbrio.
Assume it is a 351 ford windsor model?
Email Ski Dim with your engine type and they will be pleased to advise and/ or supply you.



Sent from my iPhone using Tapatalk[/

[Hercules_ZA]

Awesome, thanks!!


Sent from my iPhone using Tapatalk

[crystal waters]

Awesome, thanks!!


Sent from my iPhone using Tapatalk

Once you receive your new impeller be very careful removing the old one to ensure you then install the new one correctly and not backwards. A few chosen pictures may help you as you remove the old one.

[Hercules_ZA]

Thanks, have played with outboards for 20 years, so understand the care needed!!! Just got a response from SkiDim so will chat to the Jabsco agent in the morning!!!

Just for info here are the Specs from them;

It is a Sherwood 9959K, and the diameter is 61.9mm, and width is 31.7mm, shaft diameter 5/8”, key way 3/16”, and number of vanes is 12


Sent from my iPad using Tapatalk