Stringer question

[mlaosa]

Hey guys, I've read most of your resto posts over and over again for years and have gotten more than plenty info and appreciate it all. I'm STILL in the middle of my stringer resto. I've tried to shape the "bottom" of the main stringers to the curvature of the boat and have gone through quite a few pieces of wood doing so only because Im trying to get it done right and not have to redo this again. I've come to the realization that I'm way over thinking this. So I have between 1/4"~ 3/8" gap mainly due to the hull isn't completely flat. I'm planning to use pl premium to bed the stringers also using foam spacers. My question is..... Do I need to worry too much about the gap? I know there should be a little gap so stringers don't set right on the floor causing hard spots. Appreciate any input.

[Okie Boarder]

That amount of gap should be fine. I wouldn't worry too much about it.

[jasun]

Agreed. I think I ha e 1/2" gaps at times. I bed mine with polyester peanut butter and just filled in the gaps!


Sent from my iPhone using Tapatalk

[Jetlink]

Believe it or not but the beefy part of my stringers that sit under the engine and transmission are solid pieces of African mahogany and are pretty flush to the floors as we spent a weekend on just fabricating those two pieces alone. The rest have some gaps in places that were filled in with "peanut butter" as well.

[mlaosa]

Thanks guys. Appreciate your input. I'll just go ahead and bed the stringers and go forth. After all, supra damn sure didn't build these boats perfectly right?

[michael hunter]

I used an epoxy paste and CPES as a binder . US Composits and Rot Doctor are good for supply's.

[MarbleFalls]

The way I understand it, correct me if I'm wrong please. The most important thing is the layers of glass and resin over the new stringers, not so much the stringers themselves?