Anti-Freeze Protection Levels
The new Raptor Engines are equipped with what is commonly referred to as a "half closed cooling system". This means that the engine block (including the heater) is cooled by anti-freeze and the exhaust manifolds are cooled by raw water. The anti-freeze that we use is propylene glycol based anti-freeze. Following is a service article that I wrote regarding anti-freeze protection levels. To test the concentration of the anti-freeze in your Raptor engine you will need a tool called a refractometer. The "floating ball" type testers are not recommended. Refractometers are a bit more expensive but they will measure ethylene glycol, propylene glycol and battery acid concentrations and on top of that are a lot cooler than floating ball testers. Here is a good excuse for you "tool junkies" out there to buy something to impress your friends with!
A normal 50:50 mix of propylene glycol provides a protection level that will allow an engine to operate at -26°F (-32°C). That means that no ice crystals will form in the coolant till the temperature drops below -26°F (-32°C). This is referred to as the freezing point of the anti-freeze.
At any ratio of 35:65 (35%) or higher, propylene glycol provides additional protection to lower than -50°F (-46°C). This protection level is referred to as the burst point. The burst point is the point where the crystals in the coolant are able to expand and cause damage to the cooling system. In other words, it is OK for the coolant in the cooling system of an engine to turn to slush as long as the engine is just being stored and will not be expected to operate till the weather gets warmer.
Since it is pretty unrealistic to think that a customer will actually be using their boat at -26°F, the bursting point becomes the more important value to pay attention to. Following is a chart showing the anti-freeze ratio and the corresponding freezing point and burst point.
Ratio Freezing Point Bursting Point
50/50 (50%) -26°F (-32°C) -50°F (-46°C)
40/60 (40%) -5°F (-20°C) -50°F (-46°C)
30/70 (30%) +10°F (-12°C) -20°F (-29°C)
20/80 (20%) +20°F (-6°C) +10°F (-12°C)
A 40/60 (40%) ratio provides adequate burst protection for most of us. The 50/50 (50%) mix historically has been the recommended concentration because of the convenience being able to determine how much anti-freeze and water you need to use for a given system.
Larry Engelbert
Indmar Marine Engines
Reply With Quote
