PSS seal wants a water supply , where do y'all have yours hooked up at ? Any leads for local stores for parts
Sent from my iPhone using Tapatalk
PSS seal wants a water supply , where do y'all have yours hooked up at ? Any leads for local stores for parts
Sent from my iPhone using Tapatalk
LIFE IS TOO SHORT NOT TO BE LIVELY
usually you can tap into the tranny cooler drain screw. and its cooler water
2009 21v Worlds 340 Cat
run your engine after you change the oil
Doug
Like docdrs said above.
I believe this is the nipple I used but it would be best to double check your size, there are a few sizes and angles available.
http://www.ebay.com/itm/PSS-1051-Sta...9bBjjA&vxp=mtr
I tapped mine how the SkiDim guys told me to do it and it backed up what the instructions said however, after my issues last year the tap is now the first thing out of the raw water pump before any of that water gets to the thermostat housing.
'86 Comp TS6M - Reborn 2016
Riding a HO Sports CX Ski
The other thing I did was honed out the inside diameter of the pass through for the tap as it does not need to be that thick in my opinion, you are not going to really torque down a rubber hose with a hose clamp tight enough to where thinning it out will now allow it to crush. This removed some of the restriction to the water flow I found after installing it.
'86 Comp TS6M - Reborn 2016
Riding a HO Sports CX Ski
I'm not sure if the 351w boats are different, but on a 454 Supra the trans cooler is on the suction side of the pump. You want to tap somewhere on teh pressurized side of the raw water pump.