Results 1 to 10 of 18

Hybrid View

  1. #1
    Join Date
    Jun 2014
    Location
    Lexington, KY
    Posts
    185

    Default In Search of Tracking Fins for '86 Saltare

    I found some rocks while exploring a new-to-me lake. I'm ecstatic that it was at idle as opposed to full speed, but there is a lot of inertia behind a 23' boat with 6 adults on board, and KY limestone doesn't give. I've got some minor scars to the keel and two trashed fins. I'm looking for someone that may be parting out a boat, or if anyone knows of an aftermarket source for something close - my boat already has an aftermarket rudder and port, and driveshaft so i'm not tied to keeping it original in any way. option #3 is send them to a prop-shop for repair but I'd rather just bolt on something new if possible. My nearly new Samsung S7 (designed to be water resistant) failed and let water into the camera lens earlier the same day, so no carnage photos to share.
    Korey Morris -
    Sold to Arkansas: 1986 Supra Saltare
    Current: 2018 Moomba Craz

  2. #2
    Join Date
    Dec 2015
    Location
    Lake Nottely, Blairsville, GA
    Posts
    1,247

    Default

    I believe the proper term for tracking fins is skegs. This may help in your search. I've seen some listed here in past. Best bet is to find someone parting out a hull. Should be interchangeable across all models.

    1983 Supra Rider aka Mischief IV
    1983 Supra Beast
    1985 Supra Rider
    1986 Supra Sunsport Skier
    1987 Supra Marauder
    1991 Supra Comp ts6m
    2012 Supra Sunsport 242

  3. #3
    Join Date
    Jun 2014
    Location
    Lexington, KY
    Posts
    185

    Default

    Thanks, they seems to be referred to as "Turn Fins" too. Here is the aftermarket source that I was dreaming of. I'll give them a call when I get smarter about what is underneath my boat tonight.
    Capture.JPG
    http://www.marinehardware.com/downlo...nning_gear.pdf

    They also seem to be the manufacturer of the rudder assembly that i bought from skidim.
    Korey Morris -
    Sold to Arkansas: 1986 Supra Saltare
    Current: 2018 Moomba Craz

  4. #4
    Join Date
    Aug 2010
    Location
    NJ
    Posts
    1,393

    Default

    Marine Hardware is who I was going to recommend, they have a huge selection of running gear and underwater bits for inboards.. Measure yours and they'll have something close if not exact.

  5. #5
    Join Date
    May 2014
    Location
    Bourbonnais , Illinois
    Posts
    46

    Default

    I've had good luck with skidim.com

  6. #6
    Join Date
    Jun 2014
    Location
    Lexington, KY
    Posts
    185

    Default

    Quote Originally Posted by pirata86 View Post
    I've had good luck with skidim.com
    Good luck with this part or in General? I use them a lot, but didn't have anything like this part listed online. Likely too model specific. I need to pick up the phone, but real life has been putting thr clamps on my boat time...
    Korey Morris -
    Sold to Arkansas: 1986 Supra Saltare
    Current: 2018 Moomba Craz

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •