Results 1 to 2 of 2
  1. #1

    Default Wakeshaper on Graphics

    I apologize if this has been posted before, but does anyone have experience with using suction cup wakeshapers on graphics? The graphics I have are not a solid piece, but rather they’re cut into individual pieces. I was thinking of putting a clear vinyl wrap over the area where it would mount to give it a chance for an even surface. Thoughts?
    Attached Images Attached Images

  2. #2

    Default

    Even though the vinyl is only a few thousandths thick, it will reduce to holding power of the suction cups.
    Inland Curl wakeshapers

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •