Have had this boat now for 12M and just had the bilge fail.I have just replaced the bilge and noticed I am not getting any power from the harness when running the test function on the bilge. The switch when switched to the manual position isn't activating either yet all other switches on the panel all seem to be activating normally.

I suspect there is a breaker somewhere in the circuit and I am trying to track it down to check it and reset if needed (or replace it). I cant identify any bilge related circuits on the breaker panel under the dash. I haven't pulled the switch panel yet to see if its behind there - anyone know if there is a breaker and if so where it is located

Bilge is an Attwood Sahara 500 with the automatic float. Bilge tested fine on direct 12V power.

Any other suggestions would be welcome too.

Thanks.