Results 1 to 3 of 3
  1. #1
    Join Date
    Oct 2019
    Posts
    23

    Default 351 PC Windsor Wiring question

    I’ve installed new carb, new distributor, fuel line, filter and pump, plug wires, plugs, and wiring harness. I think I have it wired up correctly and I have it 8 degrees before TDC. I have the rotor pointed correctly also. However, I cannot understand one thing though; how and where do I connect the red and brown wires That come out of the new connection to the distributor? Can I just ground the brown on the engine block? Should I run the red wire back to the resistor and connect it to the red side of the resistor? The directions are confusing.
    Last edited by Tonymozingo; 11-17-2019 at 03:20 PM.

  2. #2
    Join Date
    Oct 2019
    Posts
    23

    Default

    Please help me

  3. #3
    Join Date
    Jul 2007
    Location
    Flowery Branch Georgia
    Posts
    2,387

    Default

    What year is the boat? Can you post pictures of the distributor and wiring?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •