Results 1 to 3 of 3

Thread: Testing motor

  1. 01-11-2020, 12:43 PM #1
    dblcola
    dblcola is offline Junior Member
    Join Date
    Dec 2019
    Posts
    4

    Default Testing motor

    Hello I just purchased a 1992 Supra with a 351 Ford and I need to know where to hook up the water hose to try and start the motor. I've looked it over and have no clue. Thanks Sorry posted in the wrong place.
    Last edited by dblcola; 01-11-2020 at 01:02 PM.
    Reply With Quote Reply With Quote
  2. 01-11-2020, 05:04 PM #2
    Mischief IV's Avatar
    Mischief IV
    Mischief IV is offline Senior Member
    Join Date
    Dec 2015
    Location
    Lake Nottely, Blairsville, GA
    Posts
    945

    Default

    Intake is on the port side of engine next to prop shaft rear of engine beside the tranny. Usually a 90 degree connector.

    1983 Supra Rider
    1991 Supra Comp ts6m
    1983 Supra Beast
    1987 Supra Marauder
    2012 Supra Sunsport 242
    Reply With Quote Reply With Quote
  3. 01-12-2020, 11:13 AM #3
    michael hunter's Avatar
    michael hunter
    michael hunter is offline Senior Member
    Join Date
    Jul 2007
    Location
    Flowery Branch Georgia
    Posts
    2,620

    Default

    Just take the hose off the connector mentioned above and put it a bucket with a hose from the house running in it . Adjust the water to match the amount the engine sucks in.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules