-
2006 Indmar 325 MPI Distributor question
I have a 2006 Launch 21 with Indmar Assault 325 MPI. I was changing the cap and rotor today and found that one of the screws was over-tightened and has cracked the housing and the other screw has begun to crack the other one so I'm weighing my options. Trying to make an epoxy or JB Weld repair seems plausible but I'm inclined to get an old distributor and just use the housing. I welcome all suggestions and opinions.
Also, does anybody know what the correct distributor is for that engine?
Thanks
Bruce
-
It’s a standard GM vortec distributor 97 to 99 Silverado suburban I believe. I also have an 06 and you will need the rinda scan tool to set cam retard angle. You can get it close enough to run, but spec is +- 2 degrees. Timing light won’t do anything. Just a heads up in case you didn’t know.
Sent from my iPhone using Tapatalk
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules