My boat is coming up on 2,000 hours and I’m rebuilding everything this winter. I’m starting with the V drive. I figured I would document it here in case anyone else gets into this project. The boat is a salt boat with closed cooling, but the bilge did a number on the v drive exterior. Photos attached. It’s getting washed tomorrow and then sand blasted. So far I did all of this with a needle scaler. I didn’t take pictures after I tore it apart but I will update later.







I’m calling Walter tomorrow to order everything. All gaskets, seals, bearings, hoses, and a good bit of hardware.


Sent from my iPhone using Tapatalk