-
Velvet Drive 71C Rebuild issue
I am trying to rebuild my trans but cannot get the snap ring to stay in on the ring gear. This snap ring keeps the clutch in place. The manual calls for a .090 thickness snap ring for it. I cannot get it to stay in place. I have taken it to three transmission re builders I know and they are clueless on how to make it stay. I have an older 70C and it is the same way. I know their must be some trick to getting this to stay in place. I have tried thinner shap rings also. As small as .065 and they will not work! Any help would be appreciated!
Last edited by knoble; 06-13-2009 at 04:33 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules