OK here goes - 89' Supra Comp Floor Resto

[jet]

Man, I wished I knew that. Im still needing some mounting ideas?? I just did a quick fix on this because Its holding up my gas tank going back in. Can you find out anything?? And, how clear is the water there where the picture was taken?? Our water here is a lil muddy and not that clear. Let me know man. How is your boat coming along??

[jet]

Got some work done this weekend. Just eneded up going with 3-amps. Amp Rack 1.jpgAmp Rack 2.jpg

[wspeedin]

Man, I wished I knew that. Im still needing some mounting ideas?? I just did a quick fix on this because Its holding up my gas tank going back in. Can you find out anything?? And, how clear is the water there where the picture was taken?? Our water here is a lil muddy and not that clear. Let me know man. How is your boat coming along??

Our water here is visible for about a foot and then it gets dark and green. Our lakes are jsut valleys that have been dammed for years.

What he does is just mount them across the transom about a foot apart from each other. He uses the same kind that you got. They light up really well. Just make sure you 5200 the holes that go through the transom. He will be doing mine in a few weeks so I will post up some pics of them when they get done.

The boat! Oh man, I finally got it back from the stringer and floor guy. While the work is done very nicely and definitely structurally sound, I would not tell anybody to go back to this guy. Yes, he did it for next to nothing, but it took him way more time than what was expected. He said he could have it done in a month, turned out to be four months. Whatever though, its all go from here!

[jet]

More toys going in! The fun part is starting. Yahoo!!Charging System 1.jpgCharging System 2.jpg

[bens250ex]

Jet can you tell me which way your fuel vent is pointing on the side of your hull? I got a ton of water in my tank yesterday and I think it was from the vent being turned the wrong way

[jet]

Mine is above the rub-rail on the side of the boat and and some (older models) are below the rub-rail on the back of the boat. Mine points to the back of the boat so If water comes over the rail while moving it wont go straight in. But for xtra protection I also clog mine at the gas station after I fill it up. I take a lil paper towel and tear off a pc and stuff about 6" of it in there with a screw driver. You have to take it out to fill up. The gas vent hose a literally 12' long so if your tank sits in the sun and heats up when its full it will swell and spit it out of the vent, also cornering will make it spit out too so clog it!! There is a vent hose valve made for boats and this problem but it was $99 for the $5 part since it said Marine on it so I passed on buying it. lol. Sounds like you will be pulling your tank now.

[bens250ex]

Yup pulled it yesterday when I got home. Fuel was full of water I am going to re rout the vent

[bens250ex]

Also how is your rear seat set up ?

[TitanTn]

Jet can you tell me which way your fuel vent is pointing on the side of your hull? I got a ton of water in my tank yesterday and I think it was from the vent being turned the wrong way

I replaced my traditional vent with vented cap. So the vent hose routes back to the fill pipe. Any expansion in the heat, or overfill at the pump just dumps fuel back into the tank. No spills over the side. No water in the fuel ever.

http://www.westmarine.com/webapp/wcs...classNum=50647

[bens250ex]

Thanks Titan I'm going to look at gettin one of those. Loosing 20 gals of gas sucked