putting a set of fusion tower speakers up i think each speaker is 200 rms, my question is what type of amp should i get? i have found a couple that will push 175 at 2 ohm bridged but my worry is that at 2 ohms using more power the amp will over heat and cut on and off. will an amp that runs at 4 ohm 175 watt rms be better? if so any suggestions?

also if the speaker is 200rms can i run 200 rms to them or do I try to keep it under 200?

found a sony xplod that pushes 185 at 4 ohm but ive always heard sony over raters there watt rms so i dont know if that a good amp