Led Lighting Subwoofer

[Dtha]

Hello, for next year I plan on adding more led's and was going to wire them into the subwoofer, except with the volume I use, It will quickly burn out the led's with too much power.

How can I remedy this? If I add a resistor to the positive wire, will it limit the amount of juice going to the lights? I am not an electrical wizard, I'm quite frankly an idiot, any help would be appreciated, thank you.

[jshepp122]

A resistor would limit ohms but not the voltage, you would need some type of transformer to limit the amount of volts going to

[Wylietunes]

If you want the LED to pulse with the music, your best bet is to get an interface controller that drivers the LEDs based of the audio signal going through it.