Page 10 of 12 FirstFirst ... 89101112 LastLast
Results 91 to 100 of 119
  1. #91

    Default

    Check the other thread...moving to Trenton this summer...can't wait to get back...boated the Trent-Severn in the Supra last year for 8 days. I miss the waterways and lakes!

  2. #92
    Join Date
    Feb 2009
    Location
    Edmond, OK
    Posts
    2,508

    Default

    Looking good! That did look like quite a tight fit in the bow area...wow!

  3. #93
    Join Date
    Feb 2012
    Location
    Kingston, ON
    Posts
    356

    Default

    Well I'm almost done! Just have some cleaning to do, replaced the fuel filler and fuel lines today. Have new rubber mat on the swim platform too! Front is completely back together, have to wire in the new radio, amp and sub. Finish installing second bilge pump, and put my decals on..... they should be done today or tomorrow. Hoping to be on the water and in the air next week. On a sad note when putting my gas tank back in I noticed that the stringers are getting "punky"... am hoping to stave off a stringer job for at least a couple of seasons before I have to do engine and stringer rebuild.... hoping for 3 but will probably only get 2. What should I be looking for before doing them? just when it's bad by the engine mounts?

    Pictures to come soon.

  4. #94
    Join Date
    Sep 2010
    Location
    Collegedale, TN
    Posts
    1,905

    Default

    Quote Originally Posted by wiatowski View Post
    Well I'm almost done! Just have some cleaning to do, replaced the fuel filler and fuel lines today. Have new rubber mat on the swim platform too! Front is completely back together, have to wire in the new radio, amp and sub. Finish installing second bilge pump, and put my decals on..... they should be done today or tomorrow. Hoping to be on the water and in the air next week. On a sad note when putting my gas tank back in I noticed that the stringers are getting "punky"... am hoping to stave off a stringer job for at least a couple of seasons before I have to do engine and stringer rebuild.... hoping for 3 but will probably only get 2. What should I be looking for before doing them? just when it's bad by the engine mounts?

    Pictures to come soon.
    Gotta prove it with pics! Sounds like some great progress though.

    You should be able to delay the stringer job until the motor mount area goes bad. You just hope that it goes bad in a way you'll notice before damage occurs. I can't remember if it was Cadunkle or Wotan on this board that had a motor sink into a rotten motor mount, the driveline became seriously out-of-line, created a hole where the prop shaft goes through the boat and his boat partially sunk. Just be sure to keep a watchful eye on the engine mounts.

    1986 Saltare
    Restoration link: http://supraboats.com/bbs/showthread.php?t=7839

  5. #95
    Join Date
    Mar 2010
    Location
    Windsor, Ontario
    Posts
    1,129

    Default

    Keep her dry inside and you will get 3 more years at least. When the stringers go bad near the engine you will know !!!! I doubt you will be able to resist some engine work before then anyhow. Drive it this summer and enjoy the surf. Wish I could be there to see your first set behind the boat..... I'm thinkin' permasmile!!!

    2003 Supra Launch " Gravity Games Edition"
    Dodge ram CTD tow vehicles....

  6. #96
    Join Date
    Feb 2012
    Location
    Kingston, ON
    Posts
    356

    Default

    just a teaser... got home today and started putting on the decals. had to finish with the gel-coat repair.. if the rain holds out hoping to have it finished tomorrow.

  7. #97
    Join Date
    Oct 2008
    Posts
    253

    Default

    I feel your pain with the tower install, I would not do another EVER, that and getting the wiring in the tubes for the tower speakers. I'll go without speakers before I ever do that again. Total PITA. Boats looking nice I dig the red.
    84 Supra Marauder
    Monster Tower
    Monster Cargo Bimini
    4 Kenwood Tower speakers (6.5)
    4 Kenwood Interior Speakers (6.5)
    2 Kenwood 6x9 rear seat kick panel
    2 Kenwood 5 1/4 in dash
    1 Kenwood Sub
    2 2ch Kenwood amp 1 2ch Fosgate amp
    2 4ch Kenwood amp 1 4ch Fosgate amp
    1 2ch Kenwood (bridged) for sub
    STRAIGHT OVER KILL.

  8. #98
    Join Date
    Feb 2012
    Location
    Kingston, ON
    Posts
    356

    Default

    Well aside from a bit of cleaning up.... I'm done. Decals put on, new radio amp and Sub installed, and mirror.... sorry not in the pics. Thanks again to Mike and Clint for the measurements. Should be on the water tomorrow.... lets hope.
    Boat Porn...
    Last edited by wiatowski; 06-07-2012 at 01:40 PM.

  9. #99
    Join Date
    Feb 2012
    Location
    Kingston, ON
    Posts
    356

    Default

    More!

  10. #100
    Join Date
    Feb 2012
    Location
    Kingston, ON
    Posts
    356

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •