Restoration progress (with pics)

[codemonkey82]

Thank you for your quick response titan. I don't know what glassing in the floor is going to be like but tearing the stringers, floor and foam out are a back breaker to say the least.

I have a couple of more questions based on your answers above:

attached are pictures of the PL (professional line) adhesive available at my local hardware store. Do any of these look familiar? They have different numbers which I assume are bond strength.

1. On question number 5. you stated that you used 5200 or 4200. What are those two numbers in reference to?
2. What did you use the CSM for if you used PL in lieu of 'Peanut Butter'?
3. Do you have a picture of what went down where the water intake (fresh water intake fitting that is through-hull) is? I have a few bolt holes in a square pattern that surround that inlet. Unfortunately whatever was there to begin with was removed before I started the project. I am including a picture for a little more insight.
4. What was the easiest way to get the stringer out from the fiberglass? I was just thinking about using the Dremel to cut along the string and then beat the heck out of them until I am able to get them loose?
5. Once I start to remove the rest of the stringers can I sit inside of the boat? I am not sure how much weight the hull can take without all the support structure.

Thank you in advance.0722151253.jpg0722151253a.jpg0722151253b.jpg0722151253c.jpg0722151011.jpg