Titan, great job on the boat! I have really enjoyed reading and following this thread. I am in the process of rebuilding my 89 pro comp. I took two week off of work and hope to be able to get the bulk of the structural work done. I have a few questions...

1. What weight cloth did you use to glass in the stringers and the cross members (I was thinking 17 oz. bi-axial cloth)?
2. When I put in the new floor do I use a light weight cloth on the bottom of the plywood or do I just coat it with epoxy resin and glass in the top?
3. I like the idea of gluing in the floor board instead of screwing it in. What type of glue should I use?
4. What did you do in place of the original plastic 'foot pan' under the dash in front of the drivers seat? Once I tore into this area I noticed a lot of rot and then found that Supra decided that they would drill a drain hole under the pan through the stringer (leading into the bilge area). If I put the pan back in I was thinking of fixing a pvc pipe as a drain running from the pan directly into the bilge area?
5. What do I use to seal any of the 'through holes'? For instance, the plates and bolts that go through the transom for the deck, the bolt holes in the bottom of the hull for the fins etc. (please see pictures)
6. For the bilge area I have seen people who have used both bilge coat and garage epoxy. Due to the ease and availability of the garage paint is that a good option and does it hold up well?
7. What should I put down on the floor over the fiberglass? I have seen people who are in favor of marine epoxy paint and people who prefer gel coat...

I'm sorry for posting so many questions in your thread but it looks like you have been through all of this and I needed some quick replies as I am in the middle of this project and the clock is ticking

Here is my thread which includes recent photos of the project if you need to see...

https://forum.supraboats.com/showthr...omp-TS6M/page3

0722151011.jpg0721151839c.jpg0721151839a.jpg0721151839a.jpg0721151839.jpg