I did not have a coaming step but there was a piece of trim (just carpeted 3/4" ply) that I just removed. Gave it a lot more room under it. I was going to have it slope down from the hinged lid to make it the same level as the seat base so that anyone sitting there didn't feel confined, but my geometry skills have long since left me. Was much easier just to do a Step down (which I think turned out better then a slope would have). I wanted the storage to be the same height as the seat base. I tried to make the main section as tall as I could because like someone else said, that side is just wasted space behind the driver seat. I have another trim piece on the side that limited the height. Otherwise I would have made it just tall enough so that my cooler could fit under there as well.
I was worried at one point because I wasn't sure I had enough angle for the pylon to fit in and slide forward so the back of the pole would fit. I clear it by about 2" though. I added just a 45* block to keep the pylon from rolling around.







Reply With Quote
