Originally Posted by
NorCalPR
Not too familiar with thr layout, but what about drilling a hole? Should be an all composite boat...
Sent from my SM-G920V using Tapatalk
There is a hole linking the mid-ship to the engine bilge area, however, the way the boat sits on the trailer and in the water, it mostly flows forward.
Drilling a hole into the bottom is not an option since this part of the hull has the point at the bottom and I do not think there would be a way to make it clean or straight enough.
2005 Supra Launch 24SSV - Indmar 8100/496HO
- 1235 Prop
- 1180 center bag and 950 rears
- Suck gate
- Big stereo
- RGB cup holders and drain light
Tow Mule - 2005 Escalade AWD 6.0
Reply With Quote
