I have a sr400 2020 and added two more speakers to tower bar that match the speakers on boat already had plug in place plugged speakers in but no sound but lights work any suggestions would be great.
I have a sr400 2020 and added two more speakers to tower bar that match the speakers on boat already had plug in place plugged speakers in but no sound but lights work any suggestions would be great.
Not uncommon for unused tower speakers wire to not be connected to the amp. No need to have then live. May be bundled up under the tower base. Not sure what amp Supra uses for their tower setups, but it may be an amp setting configuration, since it left the factory with only 2 pods.
Michael
Mikes Liquid Audio
The Supra FX one towers are partially wired for second set of speakers and the wires are not run to the factory amp and you likely need a bigger amp to drive 4 JL 8.8 towers.
The wiring runs down the port side of boat and can be reached from inside the doghouse.
When you find the speaker connectors in the doghouse area, you will need to run two more sets of wires from those connectors to the amp.
My guess is you have a 400/4 amp running your two tower speakers and will need either another 400/4 or change to an 800/8 to add the new set of speakers.
This was true on a 2018, not sure about the 2020 amps
Sent from my iPhone using Tapatalk
Last edited by Larry Arizona; 07-15-2020 at 01:13 PM.
Adam,
Did you get your issue resolved?
Sent from my iPhone using Tapatalk
No I was not able to find the wires needed to hook to the amp.
The boat has a 4I/400 and a 8I/800 amp and yes I did buy the speakers from a dealer.
Larry
would you be able to tell me where the speaker wires are located that I plugged the new speakers into I am having trouble locating them. thanks Adam