Quote Originally Posted by sybrmike View Post
Thanks. Looking to do the same powdercoat/tint job on mine. Any trick to pulling the panes from the frame? I figure just drill some rivets to get one side off, open the frame a bit to get the glass & rubber gasket out, powdercoat & tint, reassemble frame/glass/gasket, and re-rivet?

Again, lookin' real nice!
Im assumming you have rivets where I have stainless 1/4 screws,

But yeah you have to remove the whole top section of the frame and you can actaully wiggle the glass out If you was just tinting,

To remove you have to unbolt the base of the windshield frame by removing the rubber to gain access the phillips screws and 8mm, then just pull off section by section!