Roswell Lightbar LED

[KG's Supra24]

Has anyone replaced the courtesty lights in the roswell light bar. I'm referring to the lights that shine down into the boat. I would like to change these out for red ones to match the boat but not sure how big of a project we are talking.

[Sluggo]

I talked to Scott at Roswell and he hooked me up with replacement blue ones. I had about 3 or 4 LED's in each side stop working. Did not ask about changing colors.

Scott Wareham

New Product Development / Warranty Specialist

Roswell Wake Air

T:780.962.0868 Ext. 231

F:780.962.0855

www.roswellwakeair.com

[email protected]

[dusty2221]

I called and spoke with Roswell a week or 2 ago and was told that they did not offer any color other than Blue. Since you have been sent replacements, can you tell me what kind of LED's they use? I had two trains of thought, one was that the LED's were the style used on dash guages and would be soldered to a circuit board. If thats the case, it would be a bit more work removing and replacing. My other thought was if it is in fact the above, just remove the board all together and stick a few strip led lights across the opening, and then put the "S" cover back over it.

BUT, it sounds like they use a differnt style led. So if the blue ones are simply replaced, it sounds like we may be able to just buy some reds and replace them.

[Sluggo]

The replacements were one piece that included new plastic, board, wire with connector. I will see if I can get a pic of the old ones tonight.

[KG's Supra24]

Awesome!!! It would be nice if i could find a way to easily change the color.

Thanks for the help Sluggo.

[KG's Supra24]

In relation to LEDs ... Matt Laird, i saw some of your install pics. How did you get the LEDs around your tweeters?

[cmtaylor777]

Kyle,

I tore into mine last year. It's very simple. I can walk you through it.

[KG's Supra24]

Hopefully it is easy to swap for red, Chad. You saying it should be doable? Lets get something in writing. I could see a lot of people wanting to do this mod. I want to do it to match the color of my boat.

[cmtaylor777]

It's no different than a standard led. We could cut a piece of thin wood to fit In the slot. Then mount the lights to that piece and mount the plastic cover to it. It's pretty simple.
When I got my bar, someone disconnected the lights inside it. I had to go back and reconnect them. It's just two wires. Would be simple.

[KG's Supra24]

Sounds easy enough Chad. I need to go out there and pull it apart. Or pull it off the tower so I can work in the heat!!

Why would they disconnect the light?